Desk phones and headsets

Yealink parts compatibility by model

Look up which Yealink desk phones use the same handset, handset cord and hookswitch tab before you swap a part between phones or replace one. The hookswitch tab is the small plastic tab in the handset cradle that holds the handset in place when the phone hangs on a wall.

Phones that share parts

The phones in each row use the same handset, handset cord and hookswitch tab.

Models that use the same parts
T21, T23, T23
T27G, T29G
T40, T41, T42
T46, T48
T53, T54
T56, T57, T58
T19P E2, which has its own grey handset, cord and tab. They also fit the T21 and T23.

For a replacement handset or hookswitch tab, or for a model that is not in the table, contact support with the model of the phone.

Handset cords

Any standard handset cord (RJ9 plug) works on these phones. Cords differ only in the length of the straight section at each end, and a longer straight section may not sit neatly in the channel on the back of the phone. If your cord is broken, use one from another phone or buy one locally.

A coiled Yealink handset cord with a straight section and a plug at each end.

Handsets

Many Yealink handsets look the same, but small differences stop a handset from fitting a phone of another group. For example, the handset of a T41 fits only the T40 and the T42.

A Yealink replacement handset.

Hookswitch tabs

The tab pulls out of the handset cradle, turns around and pushes back in. Phones that share a handset also share this tab.

Diagram: the hookswitch tab is pulled out of the handset cradle, turned around and pushed back in.
Share
Was this article helpful?

Spotted something to improve in this article?